MakerBot Replicator 2x User Manual download pdf (Page 3)

Theloosenedhotendshoulddropdowntorestonthelevelingcard.Slidethelevelingcard

underthenozzlestomakesure.

Ifthehotenddoesnotdropdown,useahexwrenchorsomeothertooltogentlypressdownon

thetopofthethermalbarriertube.

8.Tightenthebarmountsetscrew.

Whenthetwonozzlesseemtobeatthesameheight,usethe2.5mmhexwrenchtotightenthe

setscrewandsecuretheloosethermalbarriertube.

9.Checkyournozzleheightsandadjustifnecessary.

Leveltheplateagain,thistimepayingattentiontobothnozzles.Iftheystillappeartobeat

differentheights,repeatsteps6.through8.untiltheheightsmatch.

10.Returnthemotorassemblytotheextruder.

Putthemotorassemblybackontheextrudercarriageandtightenthefanboltsatthefrontofthe

extrudertosecureit.Plugthewhiteplasticmotorwireconnectorcomingfromtheextrudercable

intotheportatthebackofthemotor.

1 2 3 4

No comments

MakerBot Replicator 2x User Manual Page 3