MakerBot Replicator 2x User Manual download pdf (Page 28)

ONBOARD OPERATIONS

1. Remove the Enclosure Lid

Lift the enclosure lid from the top of

the MakerBot Replicator 2X and set

it aside.

2. Detach the Filament Guide Tube

Locate where the filament guide

tube enters the extruder. Detach the

guide tube by gently pulling it out of

the extruder.

3. Feed the Filament through the

Filament Guide Tube

Free the end of the MakerBot ABS

Filament from your spool. Use scissors

to cut away any bent ﬁlament and

feed the end of the spooled ﬁlament

into the ﬁlament guide tube where it

attaches to the back of the MakerBot

Replicator 2X. Continue to feed the

ﬁlament in until it emerges from the

other end of the tube.

NOTE: To avoid ﬁlament jams, always

ensure that any ﬁlament spool you mount

on the Makerbot Replicator 2X feeds

from the bottom of the spool toward the

top. Filament mounted on the right spool

holder [when viewed from the back]

should always unspool clockwise and

ﬁlament loaded onto the le spool holder

should always unspool counterclockwise.

LOADING MAKERBOT FILAMENT

Filament

Guide

Tubes

Filament

Spool

Filament

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 91 92

No comments

MakerBot Replicator 2x User Manual Page 28